Chapter 2 Preparations; Connecting A Power Supply; Using A Battery Pack - Sony SRW-9000 Operation Manual

2
Chapter
Connecting a Power
Supply
This unit operates on DC 12 V (11 to 17 V)
power. Supply power by connecting it directly to
a DC power source or by using a battery pack or
AC adaptor.
Note
For safety, use only the Sony products listed below.
• BP-GL95 Lithium-ion Battery Pack
• AC-DN2B/DN10 AC Adaptor

Using a Battery Pack

When a BP-GL95 Battery Pack is used, the
continuous operating time is approximately 80
minutes.
Notes
• The battery pack operating time depends on how often
the battery pack is used, and on the ambient
temperature when it is used.
• Before use, charge the battery pack with the specified
charger.
For details on the battery charging procedure,
refer to the battery charger operation manual.
• The battery pack may not be recharged fully if
you charge it immediately after use, while it is
still warm.
• Remove the battery pack if the unit will be out
of use for an extended period.
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
To attach the battery pack
1
Press the battery pack against the back
of the unit, aligning the line on the side
of the battery pack with the matching
line on the unit.
28

Connecting a Power Supply

Preparations
1Battery pack
2Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the unit.
1"LOCK" arrow
2Matching line on the unit
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
With the unit powered off, hold the release button
in and pull the battery pack up.