Connecting An Audio Multiplexer (Mux) To The Aux In Connector (When Using The Hksr-9001) - Sony SRW-9000 Operation Manual

1 To AUDIO IN CH-1 or CH-2 connector
2 From audio equipment
3 Input selection switches
Connecting an Audio Multiplexer
(MUX) to the AUX IN Connector
(When Using the HKSR-9001)
You can multiplex audio signals into HDSDI
signals and input them to the AUX IN connector
when using the AJA HD10AMA Analog Audio
Embedder/Disembedder, HKSP-105 HD AV
Multiplexer, and HD VTRs such as the SRW-1/
SRPC-1.
Multiplexing into the HDSDI output
signals of this unit
Set REFERENCE on the <GENLOCK> page of
the Camera >MAINTENANCE menu to
INTERNAL or GENLOCK IN.
34 Connecting Audio Input
a)
HDSDI
input
Audio input
a) 75 Ω coaxial cable
b) The HD SDI MON2 connector and the HD
SDI MON1 connector on the side panel can
also be used.
To use the HD SDI OUT A connector: Set GL-
MODE on the <Genlock> page to SDI.
To use the HD SDI MON1/2 connectors: Set
GL-MODE on the <Genlock> page to MON.
Note
When SYSTEM Setup >FORMAT >INPUT SEL in the
VTR menu is set to AUX Input, it is not possible to
multiplex audio signals into HDSDI signals because
there is a phase difference between HDSDI outputs and
AUX IN inputs.
To input audio signals, multiplex them into external
HDSDI signals (see the next section "Multiplexing audio
signals into external HDSDI signals).
Multiplexing into external HDSDI signals
Set REFERENCE on the <GENLOCK> page of
the Camera >MAINTENANCE menu to AUX
IN.
a)
HDSDI
output