Sony SRW-9000 Operation Manual page 43

Step mode (STEP)
You can register and select up to eight frequently
used values as step shutter values.
Factory-set values are as follows:
STEP No. Shutter angle
1 216.0°
2 180.0°
3 172.8°
4 150.0°
5 144.0°
6 90.0°
7 45.0°
8 22.5°
Actual shutter speeds vary according to the frame
frequency and frame rate of the selected video
format. The shutter step values can be changed
and reregistered on the <SHUTTER ASSIGN>
page of the Camera >USER (OPERATION)
menu or the <SHUTTER> page of the Camera
>USER (PAINT) menu.
Continuous mode (CONTINUOUS)
This mode allows you to change shutter values
continuously over the range from 360.0 to 4.3
degrees.
To obtain a continuous shutter value quickly,
select a value close to the one you want in Step
mode, and then switch to Continuous mode to
make the final selection.
Note
When operating from a remote control unit connected to
the REMOTE connector, you can control the shutter with
the STEP (shutter step operation) or CONTINUOUS
(continuous operation) functions. There is no need to set
CONTINUOUS to ON on this unit. However, an
upgrade is required to display shutter values correctly on
the remote control unit.
For details, consult a Sony representative.
Shutter settings page
1 2
a)
4
a) Appears only when the optional HKSR-9002
is installed.
To select a shutter value in Step mode
In Step mode you can select a step shutter value
(one of up to eight registered values) as follows:
1
2
To select a shutter value by continuous operation
Continuous operation allows you to set shutter
values freely.
1
2
To change the parameter display unit
You can change the parameter display unit
between shutter angle (degree) and shutter speed
(second).
1
2
To select the frame rate (number of frames to
3
shoot)
When the optional HKSR-9002 is installed, and
you have selected the Select FPS video format,
select the frame rate (number of frames to shoot).
a)
5
Note
The frame rate cannot be changed when a format other
than Select FPS is selected.
Move the cursor to the left of "SC" (1
in the figure).
(When the unit switches to data modification
mode in the shutter settings page, the cursor
automatically appears to the left of "SC".)
Turn the MENU SEL/ENTER dial to
display the shutter value that you want
to use at 2 in the figure.
The shutter values change step by step as the
MENU SEL/ENTER dial is turned.
Move the cursor to the left of "SC" (1
in the figure).
Turn the MENU SEL/ENTER dial to
display the shutter value that you want
to use at 2 in the figure.
The shutter value changes continuously as
the MENU SEL/ENTER dial is turned.
Move the cursor to the left of
the figure).
Turn the MENU SEL/ENTER dial.
The display at 2 changes to a speed value
(seconds).
The speed value for a given shutter angle
varies depending on the selected video
format and frame rate.
Basic Settings with the Subdisplay
(2 in
43