Sony SRW-9000 Operation Manual page 91

partially recorded, you can obtain a continuous
recording by following the procedure below.
The EOS SEARCH function also allows you to
continue recording on a partially recorded tape.
1
Looking in the viewfinder, press the
PLAY button to start playback.
2
Press the STOP button at the desired
point to begin recording.
To continue from the end of a recording
already on the tape, press the STOP
button immediately after the end of the
previously recorded segment (within 0.5
seconds).
3
With the FUNC button held down,
press the PLAY button.
The tape will rewind and will be positioned at
the desired point to continue recording.
4
Press the PAUSE button to start
recording.
Note
When SYSYTEM Setup >SERVO >EOS MODE in
the VTR menu is set to "NORM", the unit plays
about 10 seconds of the recorded portion. If the end
point cannot be found, the unit enters recording
pause mode at that point.
Searching for the end of the last recorded
section and turning on recording pause
mode (EOS SEARCH function)
The EOS SEARCH LONG function allows the
unit to search for the end of a recorded section on
the tape after the recorded section is rewound and
played back.
To use this function, set SYSTEM Setup
>SERVO >EOS MODE in the VTR menu to
"LONG".
For details on VTR menu operations, see "VTR
Menu Operations" (page 170).
EOS SEARCH function
The current tape position
Tape running direction
Recorded portion
Searching for the end of the
recorded portion and turning
on recording pause mode
Note
If there is an unrecorded section between recorded
sections, the unit may behave as if that section is the end
of the last recorded section.
Blank portion
Recording 91