Rear Panel - Sony SRW-9000 Operation Manual

Rear Panel

a Battery attachment shoe
Attach a battery or AC adaptor.
For details, see "Connecting a Power Supply" (page
28).
b Tally indicator and ON/OFF switch
When the switch is set to ON, the tally indicator
lights during recording. The indicator flashes
when low voltage or an error is detected. You can
set the switch to OFF to prevent the indicator
from lighting or flashing.
See "Warning System" (page 198)" for more
information about when the tally indicator flashes.
c GENLOCK IN (external sync signal
input) connector (BNC type)
Used for input of an external genlock signal (HD
tri sync).
d TC IN (timecode input) connector
(BNC type)
Connect to the timecode output connector of a
timecode generator, VTR, or other external
device. Use this connector when you want to lock
the internal timecode generator to external
timecode.
e TC OUT (timecode output) connector
(BNC type)
Connect to the timecode input connector of a
timecode reader, VTR, or other external device.
The output signal depends on the setting of TC
Setup >OTHERS (MAIN) >TC OUT in the VTR
menu (see page 173).
f TEST OUT connector (BNC type)
Outputs an analog signal selected in the Camera
menu (see page 56).
g DC OUT (DC power output) connector
(4-pin, male)
Supplies 12 V DC power. You can connect the
power cord of the WRR-861 UHF Synthesized
Tuner Unit to this connector.
h DC IN 11-17V (DC power input)
connector (4-pin)
Connect the DC power cord of an AC-DN2B/
DN10 AC Adaptor.
For details, see "Connecting a Power Supply" (page
28).
i AUDIO IN (audio input) CH-1/CH-2
connectors (XLR type 3-pin, female
type) and input selection switches
Input audio signals to the CH-1 and CH-2
connectors.
Set the input selection switches according to the
type of the connected signal source.
LINE: When a line-level (+4 dBu) signal source
is connected
MIC: When an external microphone is connected
(no power is supplied.)
MIC +48V ON: When an external microphone is
connected (+48 V power is supplied.)
j HD SDI OUT A/B connectors (BNC
type) and ON/OFF switch (when the
HKSR-9001 is installed)
When the switch is set to ON, HDSDI signals are
output from the A and B connectors. When the
switch is set to OFF, no signals are output.
See "What Are Dual Link and 3G?" (page 210) for
more information about HDSDI signal output.
k REMOTE connector (8-pin)
Connect an external control device, such as the
RM-B150/B750 Remote Control Unit.
l AUX IN (auxiliary input) connector
(BNC type) (when the HKSR-9001 is
installed)
1.5G single link (4:2:2 30PsF or less) HDSDI
signals can be input to this connector and
Locations and Functions of Parts 19