Making Audio Signal Settings - Sony SRW-9000 Operation Manual

Making Audio Signal Settings

Use the VTR >AUDIO Setup menu to make
settings related to audio signals.
To display the AUDIO Setup menu
Press the menu selection button "AUDIO".
ADJUST knob
AUDIO Setup menu screen
Control panel
AUDIO button
To select audio signals to record
The INPUT SEL item allows you to select the
audio signals to record on each track.
1
Turn the SELECT/ENTER dial to
select a track (TRACK1 to TRACK12,
ALL MODE).
2
Press the SELECT/ENTER dial.
3
Turn the SELECT/ENTER dial to
select the signal to record on the track
selected in steps 1 and 2.
TRACK1 to TRACK12
SDI1 to SDI12 (displayed when the
HKSR-9001 is installed): SDI signal
input to the AUX IN connector
ANA1 and ANA2: Analog audio signal
input to the AUDIO INPUT CH-1 and
CH-2 connectors
SELECT/ENTER dial
OFF: Do not record audio signals (silent)
ALL MODE
Specify whether to assign signals to each
track at one time.
USER: Select the signal to record to each
track individually. (You can
configure each track individually only
if [ALL MODE] is set to [USER].)
ALL SDI: Set tracks 1 to 12 to SDI (1 to
12) at one time.
ALL ANALOG: Set tracks 1, 3, 5, 7, 9,
and 11 to ANA, and set tracks 2, 4, 6,
8, 10, and 12 to ANA2.
OFF: Set tracks 1 to 12 to OFF at one
time.
4
Press the SELECT/ENTER dial.
5
Repeat steps 1 and 2 to select other
tracks and steps 3 and 4 to select other
signals.
To select audio signals to monitor
The PHONE SEL item allows you to select the
audio signals to output to the EARPHONES jack
for the individual channels.
Cursor
L/R settings
Channel numbers
1
Turn the SELECT/ENTER dial to
select a channel (1 to 12).
2
Press the SELECT/ENTER dial.
The L/R setting of the selected channel
changes in the order L t R t LR t none.
Select "none" if you do not want to output the
selected channel to the EARPHONES jack.
Audio output levels
Recording 85