Programming Different Patterns By Splitting Each In Sequence (Split) - Brother PD-3000 Instruction Manual

Programming different patterns by splitting each in sequence (split)

Multiple patterns are programmed splitting each pattern in sequence. The following describes how to program 3
patterns in sequence.
Pattern 1
Pattern 2
Pattern 3
1. Program pattern 1.
⇒ Refer to "Pattern with lines" (page 33).
2. Press when the needle point is at point B
of the pattern.
The number of times
depends on the programming method for pattern 1.
3. Select with
.
4. Select with
.
5. Move the work clamp with
Press when the needle point is at point C
of the pattern sheet.
Pattern 1
Pattern 2
6. Press
7. Select
should be pressed
, and then press
8. Select
, and then press
9. Select ON/OFF of needle stopping at the
.
10. Press
11. Program pattern 2.
12. Program pattern 3 in the same way.
13. When pattern 3 is programmed, press
14. Carry out steps 5 to 7 of "Procedure for
PD-3000
CHAPTER 3 PROGRAMMING WITH ICONS
twice.
with
.
with
.
bottom with , and then press
.
Refer to "Pattern with lines" (page 33).
⇒
⇒ Refer to "Pattern with lines" (page 33).
programming with icons".
, and then press
, and then press
.
.
39