Modifying A Part Of Pattern - Brother PD-3000 Instruction Manual

3. Select with
.
4. Input the resizing percentage for the X and the
Y-axes.
To magnify the pattern by 150%, input 150.

Modifying a part of pattern

part of the programmed pattern is changed. The following describes how to modify 5, 6 and 7 to 5', 6' and 7'.
1. Carry out step 1 of "Procedure for modifying
program".
2. Select with
.
3. Press , and then press
The work clamp moves from the start point by each
stitch.
5. Input the stitch length, and then press
, and then press
6. Move the needle to the reference point of
7. Press
8. Press
9. Carry out steps 3 to 5 of "Procedure for
4. When the needle point reaches 4, press
, and then press
5. Press
6. Select
.
PD-3000
CHAPTER 3 PROGRAMMING WITH ICONS
To resize the pattern keeping the number of stitches
of the original data, input 0.0.
resizing with
When resizing the pattern on the basis of the home
position, there is no need to move the needle.
.
The pattern is resized.
.
modifying program".
The work clamp stops. When returning the needle
point, input the number of stitches to be returned and
press .
.
with
.
.
.
.
, and then press
47