Zigzag Stitch - Brother PD-3000 Instruction Manual

CHAPTER 3 PROGRAMMING WITH ICONS

Zigzag stitch

The following describes how to program zigzag stitch so that the sewing start point (A) is laterally centered.
Zigzag width
Pitch
Zigzag with curves may be programmed.
1. Carry out steps 1 to 3 of "Procedure for
programming with icons".
2. Select with
.
3. Select with
.
4. Select with
40
, and then press
, and then press
, and then press .
5. Input the zigzag width and the stitch length, and
then press
Input "030" to make the stitch length 3.0 mm. To
switch input between the stitch length and the width,
use .
6. Move the work clamp with
Press when the needle point is at point B
of the pattern sheet.
To program curving zigzag, repeat this step.
7. Press again.
8. Press three times.
9. Carry out step 5 to 7 of "Procedure for
programming with icons".
PD-3000
.
.