Resizing A Pattern - Brother PD-3000 Instruction Manual

CHAPTER 4 PROGRAMMING WITH COMMANDS

Resizing a pattern

Commands to be used
This function is available only when the needle point is at the home position.
1. Make sure that the needle point is at the home
position.
Press if the needle is not at the home position.
2. Determine the reference point for resizing with
.
3. Input
4. Input the magnification in 3 digits in the X
direction, and then press
Magnification values of 0 to 400 are available for
input.
138
Resizing a pattern in the X and Y directions
Used to input magnification in the X direction
Used to input magnification in the Y direction
.
.
5. Input the magnification in 3 digits in the Y
direction, and then press
Magnification values of 0 to 400 are available for
input.
6. Input the stitch length in 3 digits, and then press
.
If the value is "000", the stitch count will be
unchanged.
decreases.
PD-3000
.
The stitch length increases or