Creating Basting Data; Creating An Offset; Creating Feed Data - Brother PD-3000 Instruction Manual

CHAPTER 4 PROGRAMMING WITH COMMANDS

Creating an offset

Commands to be used
1. Select the sewing start point with
and then press .
2. Input the stitch width, and then press
.
3. Move the needle point to the second point or
after with

Creating feed data

Commands to be used
* To cancel basting, input
1. Press .
2. Determine the feed point with
130
Creating an offset. Input the width of offset stitch in
Values 1.0 to 9.9 mm are available for the width
Example: Width Input value
1.5 mm 415
Input the stitch length in
Carrying out offset on the left of the sewing path
Carrying out offset on the right of the sewing path
Starting offset calculations
(This is the code to end programming. For details, refer to page 133.）
. Press .
Specifying split (the separation point for different patterns in sewing) after feed
Moving in parallel for the feed
Creating split data after basting

Creating basting data

at the basting position.
.
PD-3000
.
4. When the needle point is moved to the corner,
,
press
5. Repeat steps 3 and 4 and move the needle to the
end point. Then input
When the calculation is complete, the needle point
moves to the end position.
3. Input command depending on the feed.
If not specified, press
.
.
.