Repeated Copying; Copying A Pattern Symmetrically To A Point; Copying A Pattern Symmetrically To The X-Axis - Brother PD-3000 Instruction Manual

CHAPTER 4 PROGRAMMING WITH COMMANDS

Repeated copying

Command to be used
1. Move the needle to the position you want to
apply the command at.
For moving the needle position, refer to "Description
of commands" (page 90).

Copying a pattern symmetrically to a point

Command to be used
1. Move to the desired needle position you want to
apply the command at.
For moving the needle position, refer to "Description
of commands" (page 90).

Copying a pattern symmetrically to the X-axis

Commands to be used
1. Move the needle to the position you want to
apply the command at.
For moving the needle position, refer to "Description
of commands" (page 90).
140
Copying data, from the sewing start point or the feed point (excluding the number of feed
boundaries to be ignored) to the current needle position, to the area after the current needle
position
Copying data, from the start point or the feed point (excluding the number of feed boundaries
to be ignored) to the current needle position, symmetrically to the current needle position
Copying data, from the start point or the feed point (excluding the number of feed boundaries
to be ignored) to the current needle position, symmetrically to the X-axis based on the current
needle position
2. Input
The needle follows the copied data. Press
stop the needle halfway.
2. Input
2. Input
PD-3000
.
.
.
to