Continuous Sewing With The Work Clamp In Position After Thread Trimming (Feed) - Brother PD-3000 Instruction Manual

CHAPTER 3 PROGRAMMING WITH ICONS

Continuous sewing with the work clamp in position after thread trimming (feed)

Set "feed" to continue sewing with the work clamp in position after thread trimming. The following describes how to
program pattern 2 with a feed after pattern 1.
Pattern 1
1. Program pattern 1.
Refer to "Pattern with lines" (page 32).
⇒
Pattern 1
2. Press three times after inputting point B.
The number of times
depends on the programming method for pattern 1.
When a linear line is programmed, press
time. When each stitch is programmed, press it
twice.
3. Select with
.
36
Pattern 2
4. Select
5. Move the work clamp with
should be pressed
three
6. Press
, and then press
7. Program pattern 2.
8. When point D is programmed, press
9. Carry out steps 5 to 7 of "Procedure for
PD-3000
with
.
Press when the needle point is at point C
of the pattern sheet.
Pattern 2
twice.
⇒ Refer to "Pattern with lines" (page 33).
times.
programming with icons".
, and then press
.
three