Modifying A Part Of Pattern - Brother PD-3000 Instruction Manual

CHAPTER 4 PROGRAMMING WITH COMMANDS

Modifying a part of pattern

A part of the programmed pattern is changed. The following describes how to modify 5, 6 and 7 to 5', 6' and 7'.
1. Carry out step 1 of "Procedure for modifying
program" to call program.
2. Press , and then press
The work clamp moves from the start point by each
stitch.
3. When the needle point reaches 4, press
The work clamp stops. When returning the needle
point, input the number of stitches to be returned and
press .
4. Move the work clamp with
Press when the needle point is at 5'.
5. Program 6' and 7' as in step 4.
110
6. Press
The needle point moves to 5.
.
7. Press
8. Input the number of stitches to be deleted, and
then press
In the example, 3 stitches ahead are deleted: press
The needle point moves to 6, 7 and 8. Points 5, 6
and 7 are deleted.
.
.
9. Carry out steps 3 and 4 of "Procedure for
modifying program" to save program.
PD-3000
, and then press .
.
.
.