Brother PD-3000 Instruction Manual page 65

6. Select with
.
7. Move the work clamp with
the needle point is at B of the pattern sheet.
Record the coordinates (values of X
Do not press .
8. Press three times.
The needle point returns to the home position.
9. Select with
.
10. Press , and then press
The work clamp moves to point C.
11. Press .
12. Select with
.
13. Select with
.
14. Move the work clamp with
, and then press
15. Turn the pulley with a hand and put a marking
16. Turn the pulley with a hand and move the
so that
17. Press
and Y ).
18. Select
, and then press
19. Select
.
20. Move the work clamp with
, and then press
21. Press
22. Carry out steps 3 to 5 of "Procedure for
, and then press
PD-3000
CHAPTER 3 PROGRAMMING WITH ICONS
equivalent of the coordinate value recorded in
step 6.
with the needle to indicate the position of point
D.
needle to the top point.
three times.
with
.
with
.
Press when the needle point is at point D
of the pattern.
.
modifying program".
an
, and then press
, and then press
.
57