Zigzag stitch
The following describes how to program zigzag stitch so that the sewing start point (A) is laterally centered.
Zigzag width
Pitch
Curving zigzag stitches are also programmable.
1. Carry out steps 1 and 2 of "Procedure for
programming with command".
2. Press
, and then press
is the command for the zigzag
stitch.
Input the width of the zigzag stitch in
3. Input the stitch length, and then press
3.0 mm is input in the example.
Input "030" to make the stitch length 3.0 mm.
CHAPTER 4 PROGRAMMING WITH COMMANDS
4. Move the work clamp with
Press
pattern.
.
5. Press
Zigzag stitch with even width to the left and the right
is programmed.
.
6. Carry out steps 4 to 6 of "Procedure for
.
programming with command".
PD-3000
when the needle point is at B of the
.
.
103