Brother PD-3000 Instruction Manual page 113

Programming
28
27
24
25
26
11
23
20 21
10
22
9
7
8
6
19
3 13
4
5
18
2
(A)
1
1. Carry out steps 1 and 2 of "Procedure for
programming with command".
2. Press
3. Move the work clamp with
Press when the needle point is at point 2 of
the pattern sheet.
4. Move the work clamp with
Press
at point 3 of the pattern sheet.
Be sure to press
corner such as point 3. If a split is not made, the
corner will be rounded.
29
32
31
30
12
33
34
15
14
16
17
, and then press .
when the needle point is
for a split at a
CHAPTER 4 PROGRAMMING WITH COMMANDS
5. Program the following noted points up to point
17 with the curve programming steps.
When there is a liner section, move the needle point
from the split to the next split, and press
.
In the example, a linear line is programmed between
points 7 and 9. Be sure to also program a linear
line for the matched section between points 24 and
26.
To return the needle point, follow the steps below.
Returning to the previous point: Press
(The needle cannot be returned beyond the previous
split.)
Returning the previous split: Press
(When the needle position is at a split, it cannot be
moved.)
Returning to the split before the previous one: Press
.
6. Press and move the work clamp with
.
point is at point 18 of the pattern.
7. Program the following points up to point 34 in
the same manner.
When programming, be sure that the points and
splits specified on the inner line are paired
respectively with those on the outer line.
If there are any points or splits that are not paired,
the needle automatically returns to the previous point.
Correct the program.
.
8. Press
Input the number of lines for a multiple stitch in
.
.
When the number is "5", input "505".
9. Input the stitch length, and then press
3.0 mm is input in the example.
Input "030" to make the stitch length 3.0 mm.
10. Press .
If the number of lines for a multiple stitch has not
been input, a buzzer sounds.
If this occurs, repeat step 8.
11. Carry out steps 4 to 6 "Procedure for
programming with command".
PD-3000
Press when the needle
, and then press .
.
.
.
105