Double Stitch - Brother PD-3000 Instruction Manual

CHAPTER 4 PROGRAMMING WITH COMMANDS

Double stitch

Use "double stitch" to program two parallel lines. The following describes how to program the double stitch to the left
of the sewing direction.
Sewing
width
Sewing
direction
Be sure to press
Placing more intermediate points such as points C and D create smooth curves.
1. Carry out steps 1 and 2 of "Procedure for
programming with command".
2. Press , and then press
is the command for the double stitch.
Input the width of the double stitch in
3.0 mm is input in the example.
3. Input the stitch length and press
3.0 mm is input in the example.
Input "030" to make the stitch length 3.0 mm.
4. Program points B, C, D and E.
98
at a point B or E where the line changes to the curve.
.
.
.
PD-3000
5. When point E is programmed, press
again to make a split.
6. Program point F.
7. When point F is programmed, press
again.
8. After pressing , input an end code.
The needle moves to points F, G and H.
9. Carry out steps 5 and 6 of "Procedure for
programming with command".