Table of Contents
Advertisement
(3) Paper misfeeds
Problem
(1)
A paper jam in the
paper feed, convey-
ing or eject section is
indicated as soon as
the power switch is
turned on.
1-5-10
Causes/check procedures
A piece of paper torn from
copy paper is caught
around feed switches, deck
conveying switch, registra-
tion switch, exit switch.
Defective feed switch 1.
Defective feed switch 2.
Defective feed switch 3.
Defective feed switch 4.
Defective feed switch 5.
Defective deck conveying
switch 1.
Defective deck conveying
switch 2.
Defective registration
switch.
Defective exit switch.
Check visually and remove it, if any.
Run maintenance item U031 and turn feed switch 1 on and off
manually. Replace feed switch 1 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn feed switch 2 on and off
manually. Replace feed switch 2 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn feed switch 3 on and off
manually. Replace feed switch 3 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn feed switch 4 on and off
manually. Replace feed switch 4 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn feed switch 5 on and off
manually. Replace feed switch 5 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn deck conveying switch 1 on
and off manually. Replace deck conveying switch 1 if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Run maintenance item U031 and turn deck conveying switch 2 on
and off manually. Replace deck conveying switch 2 if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Run maintenance item U031 and turn the registration switch on
and off manually. Replace the registration switch if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Service Manual
Corrective measures
Y104350-7
Advertisement
Table of Contents
