Table of Contents
Advertisement
18. Clean or replace the separation pulley and
then reattach the pulley to the separation
pulley unit.
* When replacing the separation pulley, make
sure that the projection of the torque limiter
fits in the separation pulley groove.
19. Refit the separation pulley unit to the deck
conveying unit.
20. Refit the paper feed pulley unit to the pri-
mary paper feed unit of cassette 1.
21. Insert the joint to the paper feed pulley shaft,
and refit the primary paper feed unit cover to
the primary paper feed unit of cassette 1.
22. Refit the primary paper feed unit of cassette
1 to the deck conveying unit.
Y104350-7
Sevice Manual
Projection
Projection
Groove
Figure 1-6-12
1-6-7
Advertisement
Table of Contents
