Table of Contents
Advertisement
5. Remove the transfer belt from the transfer
unit.
6. Replace the transfer belt and attach the belt
to the transfer unit.
* After installing the transfer belt, rotate the
transfer belt roller 2 or 3 times, it turns, and
check that the belt does not been stranded
to the belt holder front and rear.
7. Refit the front transfer guide and spring to
the transfer unit.
8. Check if the contact between the transfer
ground roller and grounding plate spring is
correct.
9. Refit the transfer unit.
1-6-64
Transfer belt
Belt holder
Service Manual
Transfer unit
Figure 1-6-119
Transfer belt
Figure 1-6-120
Transfer ground roller
Grounding plate spring
Figure 1-6-121
Tranfer belt
roller
Belt holder
Y104350-7
Advertisement
Table of Contents
