Table of Contents
Advertisement
(7-2)Adjusting the trailing edge registration
<Procedure>
Enter maintenance mode.
Enter 071 using the numeric
keys and press the start key.
Select the item to be adjusted
on the touch panel.
Press the interrupt key.
Place an original on the document
processor and make a test copy.
Is the image correct?
(copy example 2)
Press the stop/clear key.
Exit maintenance mode.
1-6-94
Start
No
Yes
End
Service Manual
Original
Touch panel display
ADJUST DATA2: CCD trailing edge timing
ADJUST DATA4: CIS trailing edge timing
Press the start key.
The new setting is stored.
For copy example 1,
increase the value using
the cursor up key.
For copy example 3,
decrease the value using
the cursor down key.
Setting range (Initial setting)
-32 to +32 (0)
-32 to +32 (0)
Changing the value by 1 moves
the copy image by 0.19 mm.
A larger preset value delays the rear end
cutting timing, and a smaller preset value
advances the rear end cutting timing.
Copy
Copy
example 1
example 2
Figure 1-6-183
Copy
example 3
Y104350-7
Advertisement
Table of Contents
