Table of Contents
Advertisement
3. Rotate the upper lever by one mark in the
direction of the higher numbers.
There are 5 marks.
4. Close the front cover.
5. Run paper through the machine and check if
it is still curled upward.
6. Repeat steps 1 to 5 until the ejected paper
does not curl upward anymore.
7. When the correction is completed, reattach
the inner left cover.
[Correcting centerfold-stapling]
1. Print test copies using various paper types.
Configure the printer for saddle stapling and
output to the main tray.
Supported paper sizes for stapling: A3, A4R,
B4, 11" x 17", 8
1/2
2. Unfold the copied paper that has been cen-
terfold-stapled, with the inside faced down
as shown in the illustration. Check that the
paper is stapled at the center.
3. If the staple position is off, enter mainte-
nance mode and run U248 to perform the
following adjustment for each paper size.
4. Select [SADDLE STAPLE ADJUST].
5. Set the setting value for each paper size.
If the paper is stapled too far toward the
paper eject side (as shown in a in the fig-
ure), decrease the setting value.
If the paper is stapled too far toward the
paper feed side (as shown in b in the figure),
increase the setting value.
Setting range: -10 to +10
Initial setting: 0
Changing the value by 1 moves the stapling
position by approximately 0.55 mm (refer-
ence value).
6. Exit the maintenance mode.
Y104350-7
" x 11", 8
" x 14"
1/2
a
Sevice Manual
Upper lever
5
4
3
2
1
Figure 1-3-45
b
Figure 1-3-46
1-3-23
Advertisement
Table of Contents
