Olivetti d-Copia 600 Service Manual page 53

7. Remove the screw and pull out the connect-
ing rail at the upper part of the finisher.
8. Cut out the hole covers at two locations on the machine.
9. Position the finisher and machine so the long pin of the connect-
ing plate aligns with the back hole of the finisher, and the two
short pins align with the holes of the connecting rail.
10. Hooking the hooks onto the brackets at the bottom of the
machine, connect the finisher to the machine.
11. Pressing down on the connecting rail,
secure it with the screw you removed in step
7.
Y104350-7
Screw
Hooks
Hole covers
Figure 1-3-29
Sevice Manual
Connecting rail
Figure 1-3-28
Back hole of the finisher
Holes of the connecting rail
Connecting plate
Long pin
Short pins
Connecting rail
Screw
Figure 1-3-30
1-3-17