Table of Contents
Advertisement
(8-6) Adjusting the amount of slack in the paper at the vertical conveying
Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
<Procedure>
Start
Enter maintenance mode.
Enter 054 using the numeric keys.
Press the start key.
Press the interrupt key.
Press the start key
to make a test copy.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the stop/clear key to
exit maintenance mode.
End
1-6-30
Yes
No
Yes
Decrease the value using the cursor down key.
Setting range: -10 to +10
Initial setting: 0
No
The greater the value, the larger the amount of slack;
the smaller the value, the smaller the amount of slack.
Service Manual
Original
Press the start key.
The new setting is stored.
Increase the value using the cursor up key.
Copy
Copy
example 1
example 2
Figure 1-6-56
Y104350-7
Advertisement
Table of Contents
