Table of Contents
Advertisement
(8-3)Adjusting the center line of image printing
Make the following adjustment if there is a regular error between the center lines of the copy image and original.
U034
(P. 1-6-28)
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
<Procedure>
Start
Enter maintenance mode.
Enter 034 using the numeric keys.
Press the start key.
Select CASSETTE
on the touch panel.
Select LSUOUT or LSUOUT
(DUP) on the touch panel.
Press the interrupt key.
Press the start key to output a test
pattern (feed paper from the
MP tray).
Is the image correct?
Press the stop/clear key to exit
maintenance mode.
End
Y104350-7
U402
U067
(P. 1-6-53)
Touch panel display
LSUOUT: Center line adjustment data
LSUOUT (DUP): Center line adjustment data for
No
Yes
U403
(P. 1-6-55)
Correct image
duplex copying (second face)
Press the start key.
The new setting is stored.
For output example 1, decrease
the value using the cursor down key.
For output example 2, increase
the value using the cursor up key.
A setting value is corrected when the sum total of
the setting value of LSUOUT and LSUOUT (DUP)
is 50 or more and a difference is less than -50.
Setting range (initial setting)
LSUOUT: -5.0 to 5.0 (0)
LSUOUT (DUP): -2.0 to +2.0 (0)
Changing the value by 1 moves the
center line by 0.1 mm.
Sevice Manual
Front (CCD adjustment)
U072
U404
(P. 1-6-92)
(P. 1-6-95)
Back (CIS adjustment)
U404
U072
(P. 1-6-95)
(P. 1-6-92)
Center line of printing
Output
example 1
Figure 1-6-53
Output
example 2
1-6-27
Advertisement
Table of Contents
