Installation Instructions; General; Location - REMEHA Quinta 115 Technical Information

7

INSTALLATION INSTRUCTIONS

7.1 General

The complete installation must comply with the current editions of relevant British
Standards and codes of practice, including the latest local and national regulations for
this type of equipment.
All gas appliances must, by law, be installed by a competent qualified engineer
registered with CORGI and holding the relevant qualifications and certificates (for
example ACOPS and IEE regs.)
Important:
The Remeha Quinta 115 is a CE certified appliance and must not therefore be
modified or installed in any way contrary to these "Installation and Maintenance
Instructions". These manufacturer's Instructions must NOT be taken as overriding
statutory obligations. Failure to install this appliance correctly could result in an unsafe
condition which can lead to prosecution. It is your own interest and that of safety to
ensure that the law is complied with.

7.2 Location

The remeha Quinta 115 is primarily
designed for wall mounting (on the
bracket supplied). The wall should be
flat, vertically plumb and capable of
supporting the full weight of the boiler full
of water. An optional floor frame can be
used for a free standing installation or
where the wall cannot carry the weight.
The temperature in the installation area
may not be higher than 40°C; this is to
guarantee the service life of the various
components.
The following minimum clearances are
required:
- Front: 600 mm
- Sides: 25 mm
- Bottom: 250 mm
- Top: 400 mm.
Remeha Quinta 115
Fig. 05 Minimum clearances around
the boiler
05.W4H.79.00026
30