Installation Instructions; General; Location - REMEHA Quinta 30 Technical Information

Code
t
1 37
2 03
3 53
4 40
5 60
6 3&
Table 12 Failure mode on service level
Example as above:
Failure code 37 indicates the return temperature sensor failed during HTG operation
(03), at a flow temperature of 53°C, a return temperature of 40°C and DHW tempe-
rature of 60°C.
7

INSTALLATION INSTRUCTIONS

7.1 General

All gas appliances must, by law, be installed by a competent qualified engineer regis-
tered with CORGI and holding the relevant qualifications and certificates (for example
ACOPS and IEE regs.)
The complete installation must comply with the current editions of relevant British
Standards and codes of practice, including the latest local and national regulations for
this type of equipment.
Important:
The Remeha Quinta 30 is a CE certified appliance and must not therefore be modified
or installed in any way contrary to these "Installation and Maintenance Instructions".
These manufactures Instructions must NOT be taken as overriding statutory obligati-
ons. Failure to install this appliance correctly could result in an unsafe condition which
can lead to prosecution. It is your own interest and that of safety to ensure that the law
is comlied with.

7.2 Location

The remeha Quinta 30 is primarily designed for wall mounting (on the bracket supp-
lied). The wall should be flat, vertically plumb and capable of supporting the full weight
of the boiler full of water. An optional floor frame can be used for a free standing instal-
lation or where the wall cannot carry the weight.
57117.indd 29 57117.indd 29
Description
Display of failure code (see Par. 10.2)
Operating mode during failure
Flow temperature during failure
Return temperature during failure
DHW temperature during failure
n/a
29
1-4-2009 14:35:51 1-4-2009 14:35:51