Table of Contents
Advertisement
PTZ CAMERA SETUP
PTZ cameras can be configured and controlled using the OpenEye recorder software. For instructions on configuring and installing your
PTZ camera, refer to the camera manual.
Enabling an Analog PTZ Camera
1.
Ensure that you have properly connected your analog PTZ camera to the recorder.
2.
On the Display screen, click Setup.
3.
Click Camera Setup, and then click PTZ Setup.
4.
Click Select Channel, and then click the analog channel you want to enable as a PTZ camera.
5.
Click Enable Pan Tilt Connection.
6.
Type the appropriate Protocol, Port, Baud Rate, Parity, Data Bits and Stop Bits for your analog PTZ camera. These must
be the same settings that have been configured on the camera itself.
7.
Set the appropriate General and Preset/Tours options.
8.
Click Apply to save your settings.
Note For more information regarding creating preset positions, PTZ tour schedules, and controlling your PTZ camera, please refer to
the Pan/Tilt/Zoom chapter of this manual.
Enabling an IP PTZ Camera
1.
Ensure that you have properly connected your IP PTZ camera to the network.
2.
On the Display screen, click Setup.
3.
Click IP Cameras, and then click Advanced Camera Setup.
4.
Select the IP camera from the Network Cameras Currently in Use list.
5.
Select PTZ Camera.
6.
Click Apply to save your settings.
48
Advertisement
Table of Contents
