Connection Guide; Connecting The Monitor; Video Inputs And Looping Outputs; Connecting To A Network - OpenEye OE2-E12016 User Manual

CONNECTION GUIDE

CONNECTING THE MONITOR

There are three available monitor outputs on the E-Series DVR.
• Composite Monitor output for CCTV monitor – BNC (Marked MAIN)
• VGA output for VGA monitor – Mini-Sub D15
• S-Video output - Mini-Din 4 (16 Channel only)

VIDEO INPUTS AND LOOPING OUTPUTS

The E-Series DVR comes with up to 16 BNC video inputs on the rear of its chassis. Each video input has a corresponding looping BNC
output beneath it for passing the video signal to another monitoring/recording device.

CONNECTING TO A NETWORK

Use the RJ45 jack or RS232 port, if using a serial modem, on the rear of the DVR when connecting to a network.

CONNECTING AUDIO

To record audio on the DVR connect the audio source to the Audio In Port (White) on the back of the chassis.
To listen to live or recorded audio connect the Audio Out Port (Yellow) to an amplified speaker system.
NOTE: The DVR audio output is a line level source which requires an amplified speaker system. The audio input can be from an
amplified source or directly from a microphone.

CONNECTING A PTZ CAMERA

The RS485 connector can be used to control Pan / Tilt / Zoom (PTZ) cameras. See the PTZ
camera manufacturer's manual for configuring the RS485 connection.
NOTE: Use the RS485 connector for external control systems such as a control keyboard.
Connect RX-/TX- and RX+/TX+ of the control system to the TX-/RX- and TX+/RX+ (respectively)
of the DVR.
27717AH
RJ45 RS232
9