Table of Contents
Advertisement
Hybrid Sensor Setup
This interface is used to link Hard Contact Sensor Inputs from supported Network Devices to the recorder software.
1.
Click Setup.
2.
Click Alarms/Sensor, and then click the Sensors tab.
3.
In the Hybrid Sensor Setup area, click Setup.
4.
Select a camera from the Network Device List.
5.
Double-click NVR Relay No, and then select a relay to assign to this camera.
6.
Click Apply.
7.
Click Apply again to save your settings.
Relays
1.
Click Setup.
2.
Click Alarms/Sensor, and then click the Relays tab.
3.
Double-click Relay Name for each relay to assign a name.
4.
Click Apply to save your settings.
32865AA
55
Advertisement
Table of Contents
