Table of Contents
Advertisement
MOTION DETECTION SETUP
The recorder allows the user to adjust several different Motion Settings and create motion detection areas.
Set up
advanced
motion area
Reduce analog signal
noise from Motion
Detection
Create a Motion Area
1.
On the Display screen, click Setup.
2.
Click Motion Detection.
3.
Select a camera from the Select Channel list.
4.
Select Detect Detail Motion Area.
5.
Click Clear Motion Area.
6.
Click Setup Advanced Motion Area.
7.
Click a Motion Detection Area shape button.
8.
Drag the mouse over the camera image.
Note To create a polygon shape, click the mouse at each point and double-click to close
the shape.
9.
Click OK.
10. Move the sliders to adjust motion sensitivity and the noise filter.
11. Define the pre-alarm and post-alarm recording time for a motion event.
Pre Alarm Recording – 0 - 120 Seconds [The number of seconds the recorder records before motion is detected—to ensure any motion
occurring between I-frames is captured, set to a value greater than 0]
Post Alarm Recording – 0 - 120 Seconds [The number of seconds the recorder records after it stops detecting motion]
Set post-alarm recording and
sensor duration
Set
pre-alarm
recording
duration
46
Advertisement
Table of Contents
