Table of Contents
Advertisement
MOTION DETECTION RECORDING
To record data only when motion is detected:
1.
Press the Setup key on the front of the DVR or remote
control and log in.
2.
Select Record > Event Setup.
3.
Set Event to On.
4.
Set MOTION level. [Normal > High > Highest > Low].
5.
Select Area and press the ENT key to set a motion area
(global setting; each channel can be configured individually).
6.
Select User Set to define a specific motion area.
7.
Use the arrow buttons and the number buttons 1, 2 and 3 to
navigate the motion area grid. (Selected motion areas are
highlighted green on the grid.)
1 = Set Mode 2 = Clear Mode 3 = Move Mode
a.
Press 3 on the front of the DVR or remote control.
b.
Use the arrow buttons to move the cursor to the desired
location on the screen.
c.
Press 1 on the front of the DVR or remote control.
d.
Use the arrow buttons to highlight the desired motion
detection area.
e.
Repeat the steps above to create additional motion
detection areas.
8.
When finished selecting motion areas press the ENT key on
the front of the DVR or remote control to save changes.
9.
Repeat as necessary for each channel.
10. When motion area setup is complete select Save to save
settings and exit setup.
27717AH
MOTION/EVENT SETUP - INPUT
CH
EVENT
MOTION
AREA SENSOR
1
ON
NORMAL
2
ON
NORMAL
3
ON
NORMAL
ON
NORMAL
4
ON
NORMAL
5
6
ON
NORMAL
7
ON
NORMAL
8
ON
NORMAL
9CH-16CH
INPUT
SENSOR
SAVE
V-LOSS
TEXT-IN
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
ACTION
EA
CANCEL
35
Advertisement
Table of Contents
