Table of Contents
Advertisement
Chapter 7 Scanning Functions
7.1
Data Verification Mode
The data verification mode verifies the code data read against the master data stored in the scanner and reports the
match status with data output. You can set the verification parameters with the configuration software
(ScannerSetting_2D).
There are two ways to enter master data--"Preset master entry" and "Scanning master entry." The former refers to
entry that you make with the configuration software (ScannerSetting_2D) in advance; the latter can be made by
scanning a code label.
7.1.1 Verification setup procedure
(1) Preset master entry
Enter the code type and data to be used for verification using the configuration software (ScannerSetting_2D). Up to
99 digits can be entered. The entered data will be sent to the host computer when you scan the "Output master data
code" given on page 17.
The entered master data will be preserved even if the scanner is turned off. To clear it, first clear the entered master
data in the host computer with the configuration software (ScannerSetting_2D) and then send the new setting data to
the scanner.
(2) Scanning master entry
Scan a code to be entered as master data in the following way:
1) Place the scanner in the data verification mode and hold down the magic key for approx. 2 seconds. (The indicator
LED should light in green.)
2) With the magic key held down, press the trigger switch to read the master code to be entered. (The scanner
operates in the trigger switch operating mode currently set.)
During the entry operation above, if the master data has fewer characters than specified (e.g., less than the specified
verification start position), the entry operation aborts with an error.
Even if "Preset master entry" has been made, you can make "Scanning master entry." If both "Preset master entry" and
"Scanning master entry" have been made, the number of characters to be verified that has been set with the "Preset
master entry" and the master data that has been set with the "Scanning master entry" will be valid.
The entered data will be sent to the host computer when you scan the "Output master data code" given on page 17.
Note: The entered master data will be cleared when:
- Customizing the scanner by modifying the parameters with the configuration software (ScannerSetting_2D) or
batch-process QR Code symbols.
- Reverting to the factory defaults by using the QR-coded parameter menu.
Note: You can enter a code as master data any number of times as long as the indicator LED is lit in green by pressing the
magic key. The code that is read last becomes the final master data.
Note: If no master data has been entered by either the preset master entry or scanning master entry, the indicator LED
flashes in red, during which it is impossible to scan codes.
15
Advertisement
Table of Contents
