Configure The Intercom Parameters; Log In To The Configuration Home Page - CyberData 011030 Operation Manual

2.3 Configure the Intercom Parameters

To configure the Intercom online, use a standard web browser.
Configure each Intercom and verify its operation before you mount it. When you are ready to mount
an Intercom, refer to
All Intercoms are initially configured with the following default IP settings:
When configuring more than one Intercom, attach the Intercoms to the network and configure one
at a time to avoid IP address conflicts.
Parameter
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway

2.3.1 Log in to the Configuration Home Page

1. Open your browser to the Intercom IP address.
Note
Note
2. When prompted, use the following default Web Access Username and Web Access Password
Operations Guide
Appendix A, "Mounting the Intercom"
For the initial configuration of the Intercom, open your browser to the default IP address:
http://192.168.3.10
Make sure that the PC is on the same IP network as the Intercom.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products.
CyberData's VoIP Discovery Utility program is available at the following web address:
http://www.cyberdata.net/support/voip/discovery_utility.html
to access the Home Page
Web Access Username: admin
Web Access Password: admin
Table 2-3. Factory Default Settings
Factory Default Setting
static
192.168.3.10
admin
admin
255.255.255.0
192.168.3.1
(Figure 2-13):
930260A
Installing the VoIP Indoor Intercom
Configure the Intercom Parameters
for instructions.
CyberData Corporation
15