Adjusting the Camera
You can adjust the local camera to obtain the best viewing
During communication, you can also adjust the remote camera,
and adjust images being sent from the remote camera.
• A malfunction may occur if the local and remote parties try to
• You cannot control the remote camera during a meeting if
• When you have installed the optional PCS-I152 LAN Board,
• You cannot control the remote camera during a meeting if the
• If you adjust the camera angle during a meeting, a motor
To select the camera to be adjusted
Before adjusting the camera, you must select the local or
remote camera to be controlled.
Press the FAR/NEAR button on the Remote Commander.
When the remote camera is selected, the indication [FAR]
appears on the monitor screen.
When the local camera is selected, the indication [FAR] does
not appear on the monitor screen.
You cannot control the remote camera if you do not set
CAMERA CONTROL to ON in the Other Setup menu.
Chapter 2 Basic Operation During a Meeting
adjust the same camera at the same time.
H.281 is not selected as the far end camera control protocol.
and holding a meeting on a LAN, you cannot control the
Compact Processor is used as the MCU.
noise may picked up by the microphone, and it may be heard
through a speaker. This is not a malfunction.
If you frequently adjust the camera, we recommend you to
use the optional PCS-A300 Microphone. After connecting the
PCS-A300 Microphone, the built-in microphone does not
For details on the setting when using the PCS-A300
Microphone, see "Audio Configuration menu" on page 86.