Labels And Markings - Christie CP4230 Setup Manual

1 Introduction
This manual is intended for professionally trained operators of Christie high-brightness projection systems.
These operators are qualified to replace the lamp and air filter, but should not attempt to install or service the
cinema projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with high-voltage,
ultraviolet exposure, and the high temperatures generated by the cinema projector lamp are authorized to
assemble, install, and service the cinema projector.
1.1

Labels and Markings

These warning labels can appear on the cinema projector:
DANGER
WARNING
serious injury.
NOTICE! Addresses practices not related to personal injury.
WARNING
WARNING
extremely high brightness can cause permanent eye damage. For protection from ultraviolet
radiation, keep all cinema projector housings intact during operation. Protective safety gear
and safety goggles are recommended when servicing.
WARNING
the concentrated light beam of the lamp.
pulled or tripped over.
(ACGIH) recommends occupational UV exposure for an 8-hour day to be less than 0.1
microwatts per square centimeters of effective UV radiation. An evaluation of your workplace
is advised to assure employees are not exposed to cumulative radiation levels exceeding the
government guidelines for your area. 2) Be aware that some medications are known to
increase sensitivity to UV radiation.
CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)
Indicates a hazardous situation which that could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or
Indicates a hazardous situation that could result in minor or moderate injury.
Never look directly into the cinema projector lens or at the lamp. The
FIRE HAZARD! Keep hands, clothes, and all combustible material away from
Position all cables where they cannot contact hot surfaces or be
1) The American Conference of Governmental Industrial Hygienists
1-1