Christie CP4230 Setup Manual page 32

Section 2: Installation and Setup
5. Connect one end of the LPS power cord into the socket on the LPS labeled CP4230/4230 cinema projector
ONLY. Connect the other end of the power cord into the socket on the front of the cinema projector.
(Figure 2-23).
WARNING WARNING
source.
WARNING!
unit, you must terminate the power connector terminal block correctly to ensure 200VAC-240VAC output.
These connectors are controlled with the power connector breaker. For more information, see the Intercon-
nect Drawing provided with your cinema projector and Section Figure 2-22 Connect LPS.
6. Turn the LPS Breaker ON.
7. If you are using the extraction unit and CP4230 cinema projector power connectors, turn them on.
2-20
DO NOT power the cinema projector directly from a building electrical
If you use the power connectors to power the CP4230 cinema projector or the extraction
to extractor
(optional)
Communication
cables
CP4230 Projector &
Extraction Unit Power
Connectors
Connect to AC at site
NOTE: Shroud removed for clarity
Figure 2-23 LPS Connection
Lamp leads
to projector
CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)