Christie CP4230 Setup Manual page 16

Section 2: Installation and Setup
• Emergency Start: Starts the cinema projector, turns the lamp on, and opens the douser when the Touch
Panel Controller is unavailable or disconnected. Press and hold this button, to close the douser and turn the
lamp off; the power remains on.
• Reset: Resets the cinema projectors electronics. After
returns to the standby mode.
• 3D: Connects the cinema projector to 3D products, such as MasterImage or Real D for polarizing and de-
ghosting 3D content during projection.
• ICP Faceplate Connections
The ICP board provides the image processing electronics for the cinema projector. The ICP faceplate includes
a number of LEDs that are only functional when the cinema projector is in full power mode.
• REGEN: (Regulators Enabled) Indicates the presence of the internal regulator enable signal. When illumi-
nated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) Indicates the state of the software application. When OFF, in a Fail state (0).
When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) Indicates the state of the operating system. When OFF, in a Fail state (0).
When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) Indicates the configured state of the FMT FPGA. When RED, unable to con-
figure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
• ICPST: (ICP FPGA State) Indicates the configured state of the ICP FPGA. When RED, unable to configure
FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main applica-
tion.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, an active source is present.
• IMB: Allows the installation of an Image Media Block (IMB).
Touch Panel Controller (TPC)
The TPC is a touch-sensitive screen that you use to control the cinema projector. It is mounted on the rear of
the cinema projector and you can use the flexible connection to adjust the viewing angle. In general, the TPC
provides users with a means for monitoring operation and status of the cinema projector. You typically use the
TPC to turn the lamp on or off, select an input device, and view status information.
You can install the TPC on a wall near the cinema projector, or you can use the optional extension cable to
control the cinema projector from a maximum distance of 100 feet.
Lamp Power Supply (LPS)
The Lamp Power Supply (LPS) (P/N 127-101103-XX) is an optional accessory for the CP4230 cinema
projector. To connect it to the cinema projector, you use two high-current lamp leads, a RS-232 serial cable and
an Interlock (Lamp Enable) cable. You can install the LPS in the optional rack stand with the cinema projector.
The LPS provides DC power for 2.0, 3.0, 4.5 and 6.0kW lamps. A breaker on the side of the LPS acts as a
power switch, and provides protection against over-current conditions of 50A or more. If a fault occurs or
excessive voltage is detected, the breaker automatically switches OFF to prevent damage.
The LPS includes two AC power outlets that you can use to power cinema projector electronics or an approved
extraction unit. Do not use these outlets to power other devices.
2-4
the cinema projector restarts
, the cinema projector
CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)