Christie CP4230 Setup Manual page 18

Section 2: Installation and Setup
NOTE: Keep the cinema projector lens as parallel to the screen as possible, even if significantly above the
screen center. When a particularly short throw distance combines with a very wide screen, you may have to
forfeit some aim and stay more parallel to the screen. In such cases, some lens offset can reduce the key-
stone distortion.
2. Locate the lamp power supply so that its cables reach the left side of the cinema projector.
3. If you are using an optional rack stand assemble the rack stand using the instructions provided with the
rack stand. NOTES: 1) For better access, wire the LPS before installing it into the rack stand. 2) Use the
hold down clamp (P/N 116-100101-01) when securing the cinema projector to the rack stand.
4. Install and secure the lamp power supply (LPS) in the rack stand:
a. Remove the right (the operator's side) panel of the rack stand.
b. Remove the cross bar.
2-6
Figure 2-3 Side View of Rack Stand
CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)