Cannot Print Over A Network - Oce CS2136 Reference Manual

Cannot print over a network

Phenomenon
Cannot print over a
network.
Cannot print over a
TCP/IP network.
Cause Corrective Action
The Ethernet cable is 1. Make sure the printer is connected to the network
not connected correctly with the correct Ethernet cable, and then turn the
to the printer's Ethernet printer on. For instructions on connecting the cable,
port. refer to the Quick Start Guide.
2. Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected
via 100 Base-TX and amber if connected via
10Base-T.
If the Link indicator is not lit, check the following
points.
•
•
•
•
The printer's IP Make sure the printer's IP address is configured
address is not correctly.
configured correctly.
(→CD "Configuring the IP Address Using GARO
Device Setup Utility")
(→CD "Configuring the IP Address Using the Printer
Control Panel")
The printer's TCP/IP Make sure the printer's TCP/IP network settings are
network settings configured correctly.
are not configured
(→CD "Configuring the Printer's TCP/IP Network
correctly.
Settings")
The computer you Make sure the computer's TCP/IP network settings are
are trying to print configured correctly.
from is not configured
(→CD "Configuring the Printer Driver Destination
correctly.
(Windows)")
40
Troubleshooting if You Cannot Print
Make sure the hub is on.
Make sure the end of the Ethernet cable is
connected correctly.
Insert the Ethernet cable until it clicks and locks in
place.
Make sure there is no problem with the Ethernet
cable.
If there is any problem, replace the Ethernet cable.
Check the communication mode with the hub.
Although the printer normally detects the hub
communication mode and transmission rate
automatically (in auto negotiation mode), sometimes
the hub settings cannot be detected. In this
case, configure the connection method manually,
specifying the communication mode in use.
(→CD "Configuring the Communication Mode
Manually")