Loading the Roll
5
Push the Release Lever back and pull out the roll paper evenly on both ends.
Insert the edge in the Paper Feed Slot (a) and advance the paper until vacuuming
paper starts.
After the paper reaches the Platen, it is automatically advanced and vacuuming
paper starts.
Important
•
Be careful not to soil the printing surface of roll paper as you pull it out. This may
affect the printing quality.
•
If the paper is wrinkled or warped, straighten it out before loading it.
•
If it is difficult to insert the roll paper in the Paper Feed Slot, insert the left or right
corner in the slot first, and then straighten the paper as you advance it.
•
Load the roll so that there is no gap between the right edge of the paper and the
Roll Holder.
Note
•
You can adjust the strength of vacuum holding paper against the Platen when the
Release Lever is open. If it is difficult to load paper, press the ▲ or ▼ button on
the Control Panel to adjust the strength. Set vacuum stronger by pressing the ▲
button or weaker with the ▼ button. Three settings are available.
6
Open the Top Cover.
10