Oce CS2136 Reference Manual page 35

Responding to Messages
Phenomenon
Cannot update firmware.
Replace part soon.
Past part replacement.
Printhead error
P Head lock cover is open.
PHead needs cleaning.
Cannot adjust printhead.
Cause
You have uploaded firmware for
a different model.
It is almost time to replace
consumables for which service
is required.
It is past the recommended
time to replace consumables for
which service is required.
An incompatible Printhead has
been installed.
There is a problem with the
Printhead.
The Printhead Fixer Cover is
open.
The Printhead must be
cleaned.
The Printhead nozzles are
clogged.
The Printhead and feed
amount cannot be adjusted
when highly transparent film is
loaded.
35
Corrective Action
Check the firmware version.
(→CD "Updating the Firmware")
You can continue to use the printer
for some time until Past part
replacement. is displayed.
Contact your Océ dealer for
assistance.
Contact your Océ dealer for
assistance.
Install a Printhead specified for use
with the printer.
(→CD "Replacing the Printhead")
Open the Top Cover. If the Carriage
is visible, replace the Printhead with
a new one.
(→CD "Replacing the Printhead")
If, after opening the Top Cover, you
see that the Carriage is not visible,
follow the steps below.
1. Close the Top Cover and press
the Online button.
2. Replace the Printhead.
(→CD "Replacing the Printhead")
Close the Printhead Fixer Cover.
(→CD "Replacing the Printhead")
Specify Printhead cleaning options.
(→P.26)
Follow the steps below to check the
nozzles.
1. Print a test pattern to check the
nozzles.
(→P.25)
2. Clean the Printhead if the nozzles
are clogged.
(→P.26)
We recommend loading a type of
paper that you often use, other than
film, before adjusting the Printhead.
(→P.27)
Adjust the feed amount manually.
(→CD "Adjusting the Feed Amount
Manually")