Oce CS2136 Reference Manual page 43

Troubleshooting If You Cannot Print as Expected
Phenomenon
Paper rubs against the
Printhead.
Cause
The paper type as specified
on the printer does not match
the type specified in the printer
driver.
Paper has been loaded
incorrectly, causing it to wrinkle.
The Printhead is set too low.
You are printing on heavyweight
paper or paper that curls or
wrinkles easily after absorbing
ink.
43
Corrective Action
Make sure the same type of paper is
specified on the printer as in the printer
driver.
(→CD "Selecting the Paper Type
(Roll)")
(→CD "Selecting the Paper Type
(Sheet)")
Make sure the same paper type is
specified in the printer driver as on the
printer.
1. Hold down the Stop button for a
second or more to cancel printing.
2. Change the paper type in the printer
driver and try printing again.
Reload the paper.
(→P.8)
(→P.12)
In Head Height, choose Automatic.
(→CD "Adjusting the Printhead
Height")
When printing on Heavyweight Coated
Paper or other paper-based media,
choose a VacuumStrngth setting of
Strong or Strongest. If paper still rubs
against the printhead, try raising the
Printhead higher in Head Height, one
level at a time.
(→CD "Adjusting the Vacuum
Strength")
(→CD "Adjusting the Printhead Height")