Stopper touches the roll. Lock the Holder Stopper lever (c) by pushing it down
toward the shaft side.
Important
•
Insert the Holder Stopper firmly so that there is no gap between the roll and the
flange of the stopper. If there is a gap, it may cause feeding problems.
Note
•
Remove any loaded paper that will not be used.
•
If the Platen is dirty, clean inside the Top Cover.
4
With the edge of the roll paper facing toward the printer, insert the Roll Holder shaft
(a) into the guide grooves (b) of the Roll Holder Slot on both sides.
Caution
•
Be careful not to drop a roll and hurt yourself when loading it.
•
Be careful not to put your fingers between the guide grooves (b) and the Roll
Holder shaft (a) when loading roll, or may hurt yourself.
9
Loading the Roll