Oce CS2136 Reference Manual page 39

Troubleshooting if You Cannot Print
Phenomenon
The printer ejects blank,
unprinted paper.
Status
The leading edge of the roll
paper was cut to straighten it.
The Printhead nozzles are
clogged.
There is little ink left.
The printer is damaged.
39
Corrective Action
This operation is normal.
When Forced is selected under Trim
Edge First in the printer menu, the
leading edge of a roll is cut after you
load the roll to ensure the edge is
straight and eliminate any scraps of
paper. The printer is ready to print after
this initial preparation.
When No Cutting is selected under
Trim Edge First, the edge is not cut
and scraps are not removed.
Print a test pattern to check the nozzles
and make sure the Printhead is in
good condition for printing.
(→P.25)
Clean the Printhead if the nozzles are
clogged.
(→P.26)
Check the ink level and replace the Ink
Tank that is low.
(→P.16)
Contact your Océ dealer for
assistance.