Oce CS2136 Reference Manual page 44

Phenomenon
The edges of the paper
are dirty.
Troubleshooting If You Cannot Print as Expected
Cause
The Platen has become dirty
after borderless printing or
printing on small paper.
The paper type as specified
on the printer does not match
the type specified in the printer
driver.
The paper is wrinkled or warped.
You are printing on heavyweight
paper or paper that curls or
wrinkles easily after absorbing
ink.
The Printhead is set too low.
44
Corrective Action
Open the Top Cover and clean the
Platen.
(→P.21)
Make sure the same type of paper is
specified on the printer as in the printer
driver.
(→CD "Selecting the Paper Type
(Roll)")
(→CD "Selecting the Paper Type
(Sheet)")
Make sure the same paper type is
specified in the printer driver as on the
printer.
1. Hold down the Stop button for a
second or more to cancel printing.
2. Change the paper type in the printer
driver and try printing again.
Straighten out the wrinkles or curls and
reload the paper. Do not use paper that
has been printed on previously.
(→P.8)
(→P.12)
If this function is not needed, deactivate
CutDustReduct. in the printer menu.
(→CD "Main Menu Settings")
When printing on Heavyweight Coated
Paper or other paper-based media,
choose a VacuumStrngth setting of
Strong or Strongest. If paper still rubs
against the printhead, try raising the
Printhead higher in Head Height, one
level at a time.
(→CD "Adjusting the Vacuum
Strength")
(→CD "Adjusting the Printhead Height")
In Head Height, choose Automatic.
(→CD "Adjusting the Printhead Height")