Overview - Valor 1500IN (NG) Installation & Owner's Manual

QUALIFIED
INSTALLER
Fire On/Off Wall Switch
(20-foot wire length)
(supplied)
Remote Handset
Wall Holder
S S S urrou S nd d d d P P P P l l l l at t e t wi it ith i t h h h
Barr r ier Screen (required)
Nar r row 1" Trim 1555LFB
and wider 3-1/2" concrete
Tr r im 1570RCS – mount
ov v er cement board, not
adjustable, CANNOT
acc c ommodate additional
fi nish h material underneath; fi fi
w w ider 3-1/2" steel Trim
155 5 0 adjustable, accepts
up p to 1" additional non-
co o mbustible fi nish over
cement board and
behi be be be hind hi hi nd nd nd t t t t ri rim. ri ri m. m. m.
W W W W all ll ll ll F F F F i i i i ni i i i sh h h
Any y wall fi nishes applied
ove e r cement board must
be non-combustible.
Combustible mantel
are ok provided they
conform to chart
(s ( ee p p . 22) )
Combustible Floor
WARNING
!
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel, and
so on because of the heat produced by the
fi replace. Avoid placing candles, paintings,
photos, and other items sensitive to heat
around the fi replace.
20

Overview

Mantel—See Mantel & Hearth Clearances
Framing—See Framing Requirements
1/2 inch thick
non-combustible
cement board –
NOT supplied
Hearth: not required.
If used, must be minimum 4"
below fi replace opening.
HOT WALL SURFACES! The wall directly
above the fi replace is constructed of non-
combustible materials and, although safe, it
may reach temperatures in excess of 200° F
depending on choice of trims. Do not touch.
Finish the wall using materials suitable for
these temperatures.
Supplied as
vertical outlet, fi eld
convertible to
horizontal outlet.
1500
Combustible Framing Allowed Beneath Fireplace.
When the appliance is installed directly on carpeting,
tile or other combustible material other than wood
fl ooring, the appliance shall be installed on a metal
or wood panel extending the full width and recessed
depth of the appliance.
WARNING
!
Optional Decorative
Light Dimmer
Switch and Fan
Speed Control—not
provided. Consult
your electrician.