Replacing Batteries; Using Handset Wall Holder; Locating Lighting, Operation And Rating Information Plate - Valor 1500IN (NG) Installation & Owner's Manual

OWNER'S
INFORMATION
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Low batteries signal: see page 14.
BEFORE changing the batteries, disconnect the
battery box from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery box and one 9 V alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life.
To replace the batteries in the battery box:
The battery box is located to the right hand side on
the bottom of the appliance behind the front panel. It
is held in place with a piece of Velcro.
Window
Receiver
The battery box is located on the bottom of
the appliance behind the front panel.
8
Owner's Information
Battery box
1. Remove the barrier screen, the side doors and the
plinth. Grab the battery box and pull it out from its
location. Do not pull the box out by the wire!
Remove side doors
2. Disconnect the battery box.
3. Remove the
screw and
slide the
cover off.
4. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the holder.
5. Replace the cover and screw in place.
6. Reconnect the battery box.
7. Put the battery box back in its position.
8. Reinstall the plinth, side doors and barrier screen.
Locating Lighting, Operation and
Rating Information Plate
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is
located on a plate at the right hand side of the fi replace
opening. The plate slides out from under the plinth.
Window
The info plate is located on the bottom of
the appliance behind the front panel.
To access the plate, remove the barrier screen, side
doors and the plinth. Grab the return edge of the
plate and slide it out of its rails. There is important
information on both sides of the plate.
Remove plinth
Info
plate