Remove Heat Shield; Convert From Top To Rear Outlet (If Required); Fit Appliance Into Framing - Valor 1500IN (NG) Installation & Owner's Manual

QUALIFIED
INSTALLER

Remove Heat Shield

Remove the heat shield from the top of the appliance
case (3 screws).
If using the top outlet, discard the shield. If using a rear
outlet, keep the shield to reinstall after converting the
top to rear outlet—see next subsection.
Remove heat shield (3 screws)
Convert from Top to Rear Outlet
(if required)
This unit is supplied with a top vent outlet which can
be fi eld-converted to a rear vent outlet.
Please note that the rear outlet requires the instal-
lation of the heat shield on top of the heater case
as indicated.
1. Remove the top outlet collar (6 screws).
Remove top outlet (6 screws)
2. Swivel the collar and install as a rear outlet (6 screws).
Swivel the outlet so
that it is oriented
towards the rear and
reinstall to heater
(6 screws)
36
Installation
3. Reinstall the heat shield to the top of the appliance
case (3 screws).

Fit Appliance into Framing

1. Remove the 4 screws
retaining the engine to its
pallet.
2. Taking great care not to
cut your hands on the
sheet metal edges, lift the
appliance out of its packing
base and place it in the
framing. Make sure that
the unit is at the right height with consideration to
the height of the hearth or combustible fl ooring.
3. Fold out four mounting tabs and recess the
appliance in the framing as shown.
4. Fasten the unit to framing using 4 screws or nails at
the mounting tabs.
Note: The sheet metal front face of the appliance is
fl ush with the framing studs.
Reinstall heat
shield to top of
appliance
(3 screws)
Appliance fl ush to framing
Rear outlet with required heat shield
N O
N -
M A C O
M B
T É
R I A
C O U S
R E
N S U X A D T I B
U L L E
I N I N
T E C O S T M A
Z L
M B R U
T E
E G
C T R I A
U S
U I I O
T I B L S
D E N S
L E O N
D ' S S
L Y
I N
E U
S T
L E
A L
M E
L A
T I O N T
N
fl ush
front mounting
face of tabs (4)
appliance